The most ideal approach to fix your Maytag washer is to evacuate the bureau. When you separate it from the washing machine, you
will have full access to all the working systems inside the machine. This makes fixes quicker, and will likewise give
an opportunity to test and investigate the whole washing machine. The Maytag utilizes a couple of latches to keep the gadget
1/Disconnect the Maytag washer control line from the divider. Close the water in the taps on the divider. Move the machine
forward and place a container under the water supply hoses on the back panel of the washer.
2/Loosen the connections of the water hoses from the back of the washer with a parrot nose cinch. Expel the hoses and
place them inside the container. There will be hints of water, so it is a smart thought to likewise have a towel adjacent to clean
up any spills.
3/Locate the three screws on the upper back edge of the control panel that safe the panel to the back of the washer.
Evacuate them with a Phillips screwdriver. Turn the control console forward and unfasten the tabs on the base of the
console from the openings in the top of the washer.
4/Wrap little pieces of sticky tape around the links that associate the diverse parts inside the control
console. Imprint the tape with a pencil to demonstrate what interfaces each link. Expel the links from every person
segment by pulling on the finish of the terminal. Inside the control console you will have full access to the temperature
switch, the weight switch, the speed switch and the clock.
5/Remove the two screws that hold the base panel of the front of the washing machine with a wrench. They are close
the floor, on the lower edge of the entrance panel. Expel this panel from the washing machine. When you evacuate it, you
will approach the water siphon, the drive belt and the engine of the washing machine.
6/Look for the two screws that hold the lower some portion of the front panel to the sides of the washing machine. Expel them
with a wrench. Turn the lower some portion of the front panel towards you and dismantle down to unfasten the upper piece of the front
panel from the top panel.
7/Place sticky tape on the top panel cover. Evacuate the two screws that hold the top panel to the sides of the washer
with the wrench. Lift the front of the top panel like the hood of a car. The top panel has two relies on the trailing
edge that enables it to rest in a service position. You presently have full access to the remaining pieces of the washing
machine, for example, the bath, the water delta valves and the assembly of the unit.(صيانة ميكروويف دايو)